Contact Us

+86-0592-5703151

Some Main Technical Parameters About Forklifts

Columnas de:Noticias de la compañía Conocer el tiempo:2021-03-29

The technical parameters of the forklift: it is used to indicate the structural characteristics and working performance of the forklift. The main technical parameters of the forklift are: rated lifting capacity, load center distance, maximum lifting height, mast inclination, minimum turning radius, minimum ground clearance, wheelbase, wheelbase, etc.

 

1. Rated load

The rated lifting weight of a forklift refers to the maximum weight of the cargo that is allowed to be lifted when the distance from the center of gravity of the cargo to the front wall of the fork is not greater than the distance between the center of the load, expressed in t (tons). When the center of gravity of the cargo on the fork exceeds the specified load center distance, due to the limitation of the longitudinal stability of the forklift, the lifting weight should be reduced accordingly.

2. Load center distance

The load center distance refers to the horizontal distance from the center of gravity to the front wall of the vertical section of the fork when a standard cargo is placed on the fork, expressed in mm (millimeters). For a 1t forklift, the specified load center distance is 500mm.

3. Maximum lifting height

The maximum lifting height refers to the vertical distance between the upper surface of the horizontal section of the fork and the ground when the forklift is fully loaded and the goods are raised to the highest position.

4. The inclination angle of the mast

The mast inclination angle refers to the maximum inclination angle of the mast forward or backward relative to the vertical position of an unloaded forklift on a flat and solid ground. The forward inclination angle is to facilitate fork picking and unloading of the goods; the backward inclination angle is to prevent the goods from slipping off the forks when the forklift is running with the goods. According to operation needs, Hyundai Forklift is a joint venture between Jingcheng Heavy Industry and Hyundai! Generally, the forward inclination angle of the forklift is 3°~6°, and the backward inclination angle is 10°~12°.

5. Minimum turning radius

When the forklift is driving at a low speed without load and turning with a full steering wheel, the minimum distances from the outermost and innermost sides of the vehicle body to the turning center are referred to as the minimum outside turning radius Rmin and the minimum inside turning radius Rmin. ·The smaller the minimum outside turning radius, the smaller the ground area required for the forklift to turn and the better the maneuverability.

6. Minimum ground clearance

The minimum ground clearance refers to the distance from the lowest point fixed on the car body to the ground outside of the wheels. It indicates the ability of the forklift to cross the raised obstacles on the ground without collision. The greater the minimum ground clearance, the higher the passability of the forklift.

7. Wheelbase and wheelbase

Forklift wheelbase refers to the horizontal distance between the centerline of the front and rear axles of the forklift. Wheelbase refers to the distance between the center of the left and right wheels on the same axis. Increasing the wheelbase is conducive to the longitudinal stability of the forklift, but it increases the body length and the minimum turning radius. Increasing the wheelbase is conducive to the lateral stability of the forklift, but it will increase the overall width of the vehicle body and the minimum turning radius.

8. The minimum width of the right-angle channel

The minimum width of the right-angle channel refers to the minimum width of the channel that intersects at right angles for the forklift to travel back and forth. Expressed in mm. Generally, the smaller the minimum width of the right-angle channel, the better the performance.

9. Minimum width of stacking channel

The minimum width of the stacking channel is the minimum width of the channel when the forklift is in normal operation.

This forklift is so cool that there are no friends!